Here are some pictures I took after the build. I was too excited to take them as I was building. I will make sure to take 'in progress' pictres on my next build.

1. Here is the Original G3 Front Panel Circuit Board.
   

2. This is the new board that I made measuring the original for the correct location of the switches and the LED. You can see that I just used some nowmal case wires for the task (from an old AT case I had in the basement).
   

3. This is the new board installed. Next time I will make my own wires as well so I can color code them properly and also make them long enough to run under the wire holder of the G3 case (where the old IDE ribbon and wires ran).
   

4. Here are the wires plugged into the motherboard.
   

Contact me here